Filament Profile Generator
Create practical starter slicer profiles from material, printer setup, and quality target.
Generated profile
- Nozzle temp230-245C
- Bed temp70-85C
- Fan20-45%
- Retraction distance0.6-1.1mm
- Retraction speed20-35mm/s
- Suggested flow99%
- First-layer speed25 mm/s
- Working speed ceiling70 mm/s
- Lower fan to preserve bonding.
- Tune wipe/coast to reduce stringing.
- Balanced mode: reliable throughput with good finish.
Related tools & guides
How to generate a filament slicer profile
Select your printer platform, extruder type, and filament family. The generator produces starter values for temperature, cooling, retraction, and flow — plus a two-step calibration plan to finalise tuning before production.
What print temperature should I start with for PLA?
210–215 °C nozzle and 60 °C bed is a reliable starting point for most PLA brands on a standard FDM printer. Direct drive extruders can often go slightly lower (205 °C). Run a temperature tower to find your specific brand's sweet spot before printing production parts.
What retraction settings should I use for PETG?
PETG is prone to stringing. Start with 1–2 mm retraction at 25 mm/s for direct drive, or 4–6 mm at 40 mm/s for Bowden. Reduce print speed to 40–50 mm/s and lower temperature to the bottom of your range. Minimal retraction often performs better than aggressive retraction with PETG.
Why does my filament profile not work on a new spool?
Filament varies between batches and brands even within the same material family. Moisture absorption also changes behaviour significantly. Run a fresh temperature tower and flow rate calibration for each new spool if you notice quality differences from your saved profile.